“Cintropur” is a water filter hull that can hold filters. “Cintropur” can be installed both before and after water treatment plants - softeners, iron removers, etc., in order to protect the equipment from maximum pollution and provide the consumer with quality water. “Cintropur” is used in both households and commercial facilities.

~ Brief principle of equipment operation:

’’Cintropur” can be installed on cold water pipes. The filter must be installed in a vertical position, thus ensuring maximum filtration efficiency. The essence of the filter is to remove dirt particles when water flows through the filter elements (filters). The installation must take into account the future operation of the filter (easy access to the filter so that the degree of contamination can be monitored and the filter element can be replaced in good time). The filters are equipped with a centrifuge that cuts the incoming water flow. The large impurity particles in the water inlet enter the flask body under centrifugal force and settle to the bottom of the flask, which can be easily drained by opening the valves at the bottom of the filter body. The particles are filtered by means of filter elements. The permeability of the filter elements is possible 5 microns, 10 microns, 25 microns or 100 microns.

~ "Cintropur" technical parameters:

                                                           Cintropur NW25               Cintropur NW32

• Connection                               1" outlet thread                     1" 1/4 outlet thread
• Maximum flow                                 5,5 m³/h                              6,5 m³/h
• Height                                            35,5 cm                                 54 cm
• Number of seals                                  2                                         2
• Max. working pressure                      10 bar                                   10 bar
• Min. working pressure                       2°C                                        2°C
• Max. working pressure                     50°C                                      50°C

~ The set consists of

• Two-part hull
• Filter key – for convenient opening of the filter hull
• Plastic mount – required for convenient surface mounting
• Filter element – 25 microns (5pcs)

~ Possible additional equipment

• Valve – for draining dirty water
• Manometer – for water pressure accounting

 

Filters and elements for „Cintropure NW25” hulls

• Filtering element

There are different degrees of purification available: “Cintropur NW25-5” (5µm);  “Cintropur NW25-10” (10µm); “Cintropur NW25-25” (25µm); “Cintropur NW25-50” (50µm); “Cintropur NW25-100” (100µm).

(The set includes 5 pieces). Intended for cleaning water from mechanical impurities (sand, sludge, rust, algae and other mechanical particles). Suitable for Cintropur filter hulls.

 

Filters and elements for „Cintropure NW32”hulls

• Filtering element

There are different degrees of purification available: “Cintropur NW32-5” (5µm); “Cintropur NW32-10” (10µm); “Cintropur NW32-25” (25µm); “Cintropur NW32-50” (50µm); “Cintropur NW32-100” (100µm).

(The set includes 5 pieces). Intended for cleaning water from mechanical impurities (sand, sludge, rust, algae and other mechanical particles). Suitable for Cintropur filter hulls.