~ “QUARTZ” series equipment characteristics:

This equipment is mainly used to purify water from mechanical impurities such as sand, algae, rust, lime, etc. solids that block water pipes and mechanisms when flowing through pipelines. The QUARTZ series treatment equipment is most suitable for commercial and industrial facilities.

~ Brief principle of equipment operation:

The untreated water from the water source is pumped to the water treatment site, where it is brought to the filtration system "QUARTZ". In the tank/s of the filtration system there is a filtration material - quartz sand, through which water is filtered from the sediment of mechanical particles.

Thus, the water after filtration is provided clean and free from mechanical sediments. This filter medium must be rinsed periodically with water. When the machine is being rinsed, the accumulated mechanical particles are rinsed down the sewerage system. The rinsing of the machine is performed automatically by means of the control mechanism at the specified time.

Important! The operation of the equipment does not require chemical reagents and this means that the device does not impair the quality and taste of water used for food, moreover, the rinsing water does not harm the biological sewerage systems.

~ Benefits of using “QUARTZ” treatment equipment:

• Long-term operation = low wear of components and filter material = due to the specificity and quality of the components and materials of the equipment.
• Fully automated operation
• Convenient operation and maintenance.

~ Water purification capacity:

• Mechanical particle size for treatment - from 25-100 (microns)

~ Equipment treatment capacity and flow rates:

The required equipment must be selected on the basis of the results of water analyzes and the required treatment capacity.

Note! Treatment capacity is not equipment flow rate. The flow rate of the equipment is generally much higher than the treatment capacity (see table below).

Note! At times when the water consumption is higher than the treatment capacity shown in the table below, the water treatment function will still be performed, but the degree of treatment will gradually decrease depending on the amount of water consumed at the time.

~ Equipment assemblage and manufacturers:

SIA "Ūdens būve" performs full equipment assembly. The equipment is assembled in the workshop of SIA “Ūdens būve”, 87 Kalnciema Street, or, if necessary, in the facility.

The components are of high quality, they have been inspected and tested. The components are of high quality, they have been inspected and tested. Manufacturers and suppliers of equipment components are the leading leaders in this field, which we believe is trust, responsibility and quality.

Control mechanisms: CLACK WS-CI or EI (USA)
Quartz stones and sand: 0.4 - 5.0m: Radasand (Sweden)
Tanks and systems: PARK Structural (Italy and Belgium)
And other manufacturers and suppliers: Components

In order to obtain additional information about the equipment, its specifications, dimensions and technical parameters, it is necessary to contact the seller by sending a request to the e-mail address This email address is being protected from spambots. You need JavaScript enabled to view it., or by calling the office telephone +371 29349862.

Equipment warranty: 3 years.